Instructions / Assembly

© 2011 Monte Carlo Fan Company
2/10/2012
5
Remove 4 screws and save to install
switch housing.
26
Install switch housing plate b y twist-
ing plate with key hole slots into
place. Replace screw removed and
tighten the 3 screws securely.
21
Connect plug from fan to switch
housing plug. Match the color strips
on the plugs.
22
Loosen 2 screws with key slots and
remove 1 screw without slot from
motor plate and save screw.
20
The screws, washers, and motor
pads are pre-installed to the blade
holders. Attach blade assembly to
motor and tighten screws securely.
19
Black capacitor box needs to be
stuck to the switch housing. Not
being attached can cause motor
noise.
Remove twin adhesive tape from the
black capacitor as shown above.
24
23
Place and press firmly on the capaci -
tor to stick it to the switch housing.
Be sure it is secure.
25
Install the switch housing using the 4
screws previously removed.
Setting the reverse switch in the
left hand side will result in down-
ward airflow and setting the
switch in the right hand side will
result in upward airflow.
27
Reverse
switch