Installation Guide

ManualsBrandsMonte Carlo ManualsCeiling FansLight Cast Max 52 in. Roman Bronze Ceiling Fan

8/1/2013

/2013

Fig. 9

Fig. 10 Fig. 10-1

Fig. 11

Reverse switch

Screws

Blade

Blades bracket

Screws

Washers

Pull chain

Set screws

Install pull chains to preassembled pull chains on fan. Pull chains

provided. (Fig. 11)

Forward/Reverse switch setting

Setting the reverse switch in the right hand side will result in

downward airﬂow and setting the switch in the left hand side will

result in upward airﬂow.

Note: Reverse switch must be set either way completely. If the

reverse switch is set in the middle position, fan will not operate.

(Fig. 11)

Operation and Maintenance

Refer to operation and maintenance on the second page of parts

list.

Blade installation

Install blade bracket with blade by 3 blade screws and washers provided.

Tighten screws securely. Repeat this process for remaining blades. (Fig. 9)

Remove shipping stabilizers from motor assembly.

Install the blade assembly to motor using the preinstalled screws. Tighten

screws securely. Repeat this process for remaining blade assemblies. (Fig. 9)

Note: Tighten blade bracket screws twice a year.

Switch housing installation and wiring

Loosen 2 and remove one set screws from the plate on motor, keep screw.

Attached top switch housing onto the plate on motor, aligning its keyhole

slots with the set screws on the plate and twist clockwise until tight. Reinstall

the screw which is just removed and tighten all screws securely. (Fig.10)

Attach capacitor onto top switch housing by preadhered double-sided foam

tap as shown.

Connect the plug from fan to the plug from switch housing, aligning the claps

and make sure plugs connected securely. (Fig. 10-1)

Remove 4 set screws from top switch housing, keep screws.

Align the long slot on top switch housing with the reverse switch on switch

housing, and then install the switch housing onto the fan with the 4 side

mount screws which were just removed.

Top switch housing

Switch housing

Capacitor

Plate on motor

Set screws

電容器

shipping stabilizers

Long slot

Reverse switch