OWNER’S MANUAL Ceiling Fan Installation Instructions Total fan weight with light kit For 5OR52XXD Series Fans READ AND SAVE THESE INSTRUCTIONS QUALITY CEILING FANS
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes ANSI/NFPA 70-1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer. 3.
7 8 Canadian mounting only Safety Cable 9 Lag Screw Lag Screw Safety Cable Washer Hang assembled fan from the mounting bracket installed to ceiling in previous step. Make sure the fan is hanging straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball. This must be done to prevent the fan body from rotating when the blades are in motion.
19 21 20 Hands free hook Place canopy over fan body aligning holes. 22 Replace the 3 screws removed and tighten securely. Check motor for shipping stabilizers and remove if present. from mounting bracket by the hands free hook into a closed hole on the edge of the Canopy. Note: For Canadian mounting refer to Step #8. 23 24 Black White Ground Take 4 screws from hardware pack and insert 2 one on each side of bracket to match the L slot screw holes in canopy. Keep 2 screws for later use.
31 32 33 Tighten keeper nut onto threaded pipe from the light kit. Install 3 x 60 watt Candelabra base bulbs. Locate blue and white wire from the fan marked “For light kit”. Connect blue from fan to black from light and white from fan to white from light by pushing connectors together. 34 35 36 Attach switch cap to fan by lining up 2 slot ear holes and 1 screw hole and twisting cap. Then tighten the 3 screws. Remove finial nut, finial cap, hex nut, and washer from fitter.
TROUBLE SHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.
