Owner’s Guide and Installation Manual 5SI Series Fan UL Model No. :AC-212-002 Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: MODEL NUMBER: RETAILER ADDRESS: To register your fixture, please visit our website www.montecarlofans.com 18.55 kgs 40.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1999), including fire-rated construction. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer.
1 2 OUTLET BOX METHOD For Installation in The U.S. only 3 BUILDING STRUCTURE METHOD Outlet box Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. 4 Install canopy and yoke cover over the downrod. 7 Warning-Risk of fire, electric shock, or personal injury.
10 11 12 Fan House Black Black White White Light Switch Green Green(downrod) Green(Bracket) Fan Switch Blue Wall Control Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment-grounding conductor on one side of the outlet box and ungrounded conductor on the other side of the outlet box.
19 21 20 Twist into locking position and tighten in screw taken out. Also tighten 2 other loosened screws. Connect male to female connector securely. Remove 3 screws and save. 22 Reinstall the switch housing using the three screws previously removed. For Light Kit Installation Only Loosen the decorative cover first, it will make it easier to loosen the finial cap and switch cover for light kit installation.
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.
Jan.2012 New format Jun.
