Specification

© 2013 Monte Carlo Fan Company
6/15/2013
4
Lift the motor housing up aligning the L
shape holes with the screws and
washers on the mounting plate. Turn the
housing clockwise to hold in position. In-
stall the other two screws and washers
previously removed securely.
11
Loosen the two screws and washers
across from each other on the ridge
of the mounting plate. Remove the
other two screws and lock washers.
Save for later use.
10
Lift the decorative ring up and twist
clockwise till tight.
12
Check the motor for shipping stabiliz-
ers and remove if present. Attach
blades using screws and washers in
hardware pak. Tighten screws se-
curely.
13
Loosen 2 screws and remove 1 screw
from motor plate. Save removed
screw for use later.
14
Connect plug from fan to switch
house plug.
16
Install by twisting clockwise, add 1
screw removed step 14 to switch
housing plate. Tighten the 3 screws
securely.
15
Connect white wire from fan to white
wire from light fixture. Then plug
blue wire from fan to black wire from
light fixture.
18
Loosen the pre installed screws of
switch housing plate.
17