Installation Sheet

ManualsBrandsMonte Carlo ManualsCeiling Fan PartsWhite Reversible Wall/Hand-Held Remote Control Kit

CK-300-ENG

1. Model CD-52, manufactured by Ja Yang (E106510)

CK-300

Top view of switch housing plate.

Disconnect Molex Connectors in switch housing

plate by pushing down on tab and pulling the

two (molex connectors) apart.

CAUTION: To reduce the risk of electric shock,

install only in Fan

CAUTION : FOR CONTROL OF SHADE POLE, PERMANENT SPLIT

CAPACITOR, OR UNIVERSAL MOTORS ONLY.

Connect the molex from the receiver to the

molex in the switch housing plate b

y aligning

and sliding together. Note: For longer distance

operation, coil receiver antenna around the

natural wire (white wire).

Align gap in receiv

er with the screw between

speed switch and reverse switch and slide

receiver (Dip switch facing housing plate) into

switch housing plate. R

eceiv

er should fit direct

ly into area in the switch housing plate. Note:

If installing light kit, use the blue and white

wire from the receiver.

Set dip switches on the R

emote T

ansmitter and

Remote Receiver to the same settings. This

must be done so the units will communcate

properly. If you have other fans you can set to

control from one tr

ansmitter b

y setting both

receivers the same as the transmitter. If you

e more than one fan with remote. You can

set the dip switches to different positiosns to

have seperate control.

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

2. Model 9701, manufactured by Furn Fan (E141261)

3. Model AC-552, manufactured by Air Cool (E75795)

For Monte Carlo Remote

Caution: T

urn off power at fuse box to avoid

possible electrical shock.

Summary of content (4 pages)

PAGE 1
CK-300-ENG CK-300 For Monte Carlo Remote CAUTION: To reduce the risk of electric shock, install only in Fan 1. Model CD-52, manufactured by Ja Yang (E106510) 3. Model AC-552, manufactured by Air Cool (E75795) 2. Model 9701, manufactured by Furn Fan (E141261) CAUTION : FOR CONTROL OF SHADE POLE, PERMANENT SPLIT CAPACITOR, OR UNIVERSAL MOTORS ONLY. 1 2 3 Caution: Turn off power at fuse box to avoid possible electrical shock. Top view of switch housing plate.
PAGE 2
The wall control transmits the command signals via radio waves to the receiver installed in the fan’s hanging bracket or on the fan. The receiver is required for the wall control to function. Power for the wall control comes from the 12V battery located in the wall remote. Duracell MN21 / Eveready A23 / GP 23A all 12V. The frequency switches (dip switches) on the wall control and the receiver have been preset at the factory.
PAGE 3
Remote Control Transmitter Features: LED LIGHT Forward/Reverse (Press once to change direction of the fan. MEDIUM SPEED LOW SPEED HIGH SPEED FAN OFF SETTING (Turns fan off only) LIGHT ON/OFF SETTING AND DIMMER (Press and hold to dim light infinitively) FAN SPEED Depress “l dot” for low speed, “2 dots” for medium or “3 dots” for high. To turn fan off press square”. LIGHT DIMMER To turn light on, press light dimmer once quickly. To turn off press once quickly while light is on.
PAGE 4
8/29/07 REV.