Installation Sheet

The wall control transmits the command signals via radio waves to the receiver

installed in the fan’s hanging bracket or on the fan. The receiver is required for

the wall control to function. Power for the wall control comes from the 12V bat-

tery located in the wall remote. Duracell MN21 / Eveready A23 / GP 23A all 12V.

The frequency switches (dip switches) on the wall control and the receiver have

been preset at the factory. Please recheck to make sure the switches on the wall

control and receiver are set to the same position. Any combination of settings are

fine as long as the wall control and ceiling fan receiver are set to the same posi-

tion.

CAUTION: TURN OFF POWER AT FUSE BOX TO AVOID POSSIBLE ELECTRICAL SHOCK.

Install wall control unit to outlet box

using machine screws provided.

Attach front cover to wall control

with screws provided. Snap battery

cover in place.

Remove cover by snaping off from top or bot-

tom. Remove battery cover. Install 12V battery

into wall remote. Duracell MN21 / Eveready A23

/ GP 23A all 12V.

Place face plate over battery compartment and

buttons. Place remote over 2 pins on front

cover. Attach cover of remote by placing over 4

pins and snaping into place.

HAND HELD INSTALL

ALL MOUNT INSTALL