Installation Sheet

ManualsBrandsMonte Carlo ManualsCeiling Fans4 Speed Wall Control for Ceiling Fans

SAFETY INFORMATION AND GENERAL GUIDE

READ AND SAVE THESE INSTRUCTIONS

• Please read and understand this entire manual before attempting to assemble, install or operate

the product.

• Make sure that all electrical connections comply with local codes, ordinances, the National

Electrical Code and ANSI/NFPA 70. Hire a qualified electrician or consult a do-it-yourself wiring

handbook if you are unfamiliar with installing electrical wiring.

Warning

: Before proceeding, be sure to shut off electricity at main switch or circuit breaker in

order to avoid electrical shock.

ESSWC-9-WH WALL TRANSMITTER

INSTALLATION AND OPERATION INSTRUCTION

Note

: Fan installation must be complete including assembly of blades before testing wall control

unit.

Note: Refer to your Ceiling fan instruction manual for Safety and installation instruction.

This wall controller is to be used for the control of ceiling fan and fan light only.

Warning: Do not exceed maximum rating of the wall transmitter. Install the wall transmitter

away from excess heat or humidity

Customer Service

800-969-3347

Customer Service Center

7400 Linder Ave.

Skokie, IL 60077

www.montecarlofans.com

Summary of content (5 pages)

PAGE 1
ESSWC-9-WH WALL TRANSMITTER INSTALLATION AND OPERATION INSTRUCTION SAFETY INFORMATION AND GENERAL GUIDE READ AND SAVE THESE INSTRUCTIONS • Please read and understand this entire manual before attempting to assemble, install or operate the product. • Make sure that all electrical connections comply with local codes, ordinances, the National Electrical Code and ANSI/NFPA 70. Hire a qualified electrician or consult a do-it-yourself wiring handbook if you are unfamiliar with installing electrical wiring.
PAGE 2
Warning: Before proceeding, be sure to shut off electricity at main switch or circuit breaker in order to avoid electrical shock. Make series-wound connection for the wall transmitter with HOT wire from house. Connect a black wire from wall transmitter to the HOT wire and then connect the other wire to the LOAD wire in outlet box. Black To Fan Note: The ON/OFF switch is to turn the power of fan on/off.
PAGE 3
Wall Transmitter Installation, Wiring and Setting Common Mode and Learning Mode Remove wall plate and switch cover by finger or using a small pointed object as shown in figure 4. Open End There are “COMMON” and “LEARN Mode” with the remote controller. If choosing “COMMON”, simply place the dip (code) switch at UPPER position. Your fan with the remote controller is ready to use. (Fig. 4) Note: If using universal mode, your fan can be controlled with other remote transmitters with the same setting.
PAGE 4
Tips for end users 1. If your fan is operated automatically after installation and power on, it is because your fan is still memorize the previous setting at factory. Use universal mode or make learn function setting and your fan will be ready for use. 2. If fan or light isn’t working, reset power (turn the power off for at least 10 seconds, then turn the power back, and redo the learn function setting. You must press the “SET” button within 1 minute of restoring power to the fan. 3.
PAGE 5
Jul.