Installation Guide

TROUBLESHOOTING

1. Check blue wire from fan to make sure it is connected to hot wire from house.

2. Check for loose or disconnected wires in fan switch housing.

3. Check for loose or disconnected wires in light kit.

4. Check for faulty light bulbs.

CAUTION: Make sure main power is turned off before entering switch housing.

WARNING: Over lamping the fan will result in the fan lights shutting down until the proper wattage of bulbs

are installed. Reset the lights by turning off the wall switch, breaker, or by remote. Replace bulbs with the

correct wattage bulbs, turn the power on.

Attach glass to light pan by locating

dimples in light pan with grooves in glass

and twist clockwise until tight.

Install fan pull chain and light kit pull

chain to preassembled pull chains on light

kit or fan. Pull chains provided.

Glass

Light pan

Pull chain

6/2019