Installation Sheet

Before you begin installing the light kit,
Switch power off at Service panel and
lock service disconnecting means to
prevent power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
Remove switch housing from top cover of
switch housing by removing set screws (if
it has been installed with the fan. Keep
screws. Unplug the lead wires
Remove the taps from switch husing as
shown in illustration.
Remove hex nut and lock washer from light
kit. Keep parts.
Thread lead wires from light kit through
central hole in switch housing and then
install switch housing onto light kit by
turning clockwise till tight.
Place the lock washer and hex nut removed
on installation step 4 over the lead wires
from light fixture and tighten securely with
the thread rod of light kit.
Install a light switch onto switch
housing. Light switch provided.
Connect black wire from light switch
to black wire from light kit.
Connect blue wire from light switch
to blue wire from switch housing.
Connect white wire from switch
housing to white wire from light kit.
Make sure all quick connectors are
securely connected.
Connect the plug from switch
housing with light kit to the plug
from fan. Make sure the plugs are
firmly clasped.
Install light kit assembly (switch
housing) onto the fan with the set
screws removed in step 2.
Install pull chain. Pull chain
provided.
ON
OFF
ON
OFF
Switch
housing
Hex nut
Lock washer
Tap
Tap
Light switch
Install light kit with fans use pull chain control
Refer to page 4 for fans with remote controller
Black
Black
Blue
Blue
White
White
Switch housing
Light kit
Light kit
Hex nut
Lock washer
3
© 2019 Monte Carlo Fan Company
8/2019
1
2 3
4
5
6
7
8