Installation Sheet

MC93 SLOPED CEILING KIT

READ AND SAVE THESE INSTRUCTIONS

Warning: Make sure main power is turned off before handling parts

replacement.

Installation work and electrical wiring must be done by qualified person(s). If you

are unfamiliar with methods of installing or electrical wiring, secure the service of a

qualified electrician.

All electrical connections must be in accordance with local codes, ordinances, and

national electrical codes.

Review the installation instructions supplied with your fan. Make sure that your fan

has been wired properly into the ceiling.

Warning: Cross pin and keeper pin must be installed securely with yoke and

downrod, and the pin in hanger ball must be installed in slot of hanger ball and

through downrod, failure to install them will result in serious injury.

Customer Service

800-969-3347

Customer Service Center

7400 Linder Ave.

Skokie, IL 60077

www.montecarlofans.com

Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver,

Pliers, Safety Glasses, Stepladder and Wire Strippers

PAGE 1
MC93 SLOPED CEILING KIT READ AND SAVE THESE INSTRUCTIONS Warning: Make sure main power is turned off before handling parts replacement. Installation work and electrical wiring must be done by qualified person(s). If you are unfamiliar with methods of installing or electrical wiring, secure the service of a qualified electrician. All electrical connections must be in accordance with local codes, ordinances, and national electrical codes. Review the installation instructions supplied with your fan.
PAGE 2
1 2 ON ON OFF OFF Before you begin handling parts replacement, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. 3 1 2 3 4 Unpacking the Kit and make sure all the components included. 1. Mounting bracket with 2 canopy screws. 2.Canopy 3. Hanger ball 4.
PAGE 3
5 6 7 Pin Pin New hanger ball Hanger ball Canopy Setscrew Setscrew Cnopy bottom cap Downrod Downrod Yoke cover Downrod Loosen the set screw. Remove the hanger ball and pin on the downrod in fan package. Keep parts. 8 Install the new hanger ball and the pin onto the downrod. Warning: Make sure the pin is installed well on hanger ball with downrod. Tighten the set screw securely. 9 Ceiling peak Refer to the fan installation instruction manual for fan, safety cable installing and wiring.
PAGE 4
Apr.