User's Manual

01/11/12

3.1.2.2 MINI DIN 6 pin connector pin assignment

PIN SIGNAL

1 Data

2 Reserve

3 Ground

4 VCC

5 Clock

6 Reserve

Shield Frame Ground

3.1.3. Contact Resistance : 500 ohm Max.

3.1.4. Insulation Resistance : 100 ohm, 250V DC

3.1.5. Bounce : ≦ 10 MilliSecond

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO

OR TV INTERFERENCE CAUSED BY UNAUTHORIZED

MODIFICATIONS TO THIS EQUIPMENT. SUCH

MODIFICATIIONS COULD VOID THE USER’ S AUTHORITY TO

OPERATE THE EQUIPMENT.

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

Designed to provide reasonable protection against harmful interference in a

Residential installation. This equipment generated, uses and can radiate radio

Frequency energy and, if not installed and used in accordance with the

Instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

Receiver is connected.

Consult the dealer or an experienced radio / TV technician for help.