OWNER'S MANUAL 4-DRAWER BASE CABINET WITH WORKTOP MG30244BC www.montezumastorage.
LIFE ORGANIZED Montezuma is committed to helping you succeed in both your work and personal life by being organized, prepared and equipped with the right tools, gear and home supplies at your finger tips. We are here to ensure that your life is organized. Thank you for your purchase of this Montezuma 2-Drawer Base Cabinet. ATTENTION TO REDUCE THE RISK OF INJURY, THE USER MUST READ AND UNDERSTAND THIS INSTRUCTION MANUAL BEFORE USING THIS PRODUCT FOR THE FIRST TIME.
SPECIFICATIONS 4-DRAWER BASE CABINET WITH WORKTOP MG30244BC BASE CABINET OVERALL DIMENSIONS: 30-1/2" W x 24-1/8" D x 34-3/4" H (77.6 cm W x 61.3 cm D x 88.1 cm H) NET WEIGHT: 125.7 lb (57 kg) MAXIMUM WEIGHT CAPACITY: 500 lb (227 kg) MAXIMUM DRAWER CAPACITY: 100 lb (45 kg) INSIDE DRAWER DIMENSIONS: REF DIMENSIONS QTY A 26-3/8" W x 20-3/4" D x 5-1/4" H (67.1 cm W x 52.8 cm D x 13.4 cm H) 2 B 26-3/8" W x 20-3/4" D x 8-1/4" H (67.1 cm W x 52.8 cm D x 20.
PARTS LIST 2 1 10 2 9 3 4 The keys are taped to the top drawer of the cabinet.
1 Stainless Steel Worktop 5 3 M6 x 16 Hex Socket Head Screw 4 for attaching worktop Washer For attaching to top of cabinet 1 for attaching unit to other units For use with M6 x 65 Hex Tapping Screw 3 2 4 M6 x 65 Hex Tapping Screw End Cover For covering holes for attaching to other units, if not in use Adjustable Feet For securing unit to the wall 4 4 1 xxx For attaching to bottom panel Slide Set Lock and Key Pre-installed Drawer Liner For installing drawers For protecting drawers F
ASSEMBLY Visit www.montezumastorage.com to watch the how-to video. Carefully lay the cabinet on its back, with a soft mat underneath for protection. Screw the four adjustable feet into the cabinet bottom. Turn the cabinet upright.
To add a worktop, remove the top drawer from the cabinet. Attach the worktop to the cabinet using four M6 x 16 hex socket head screws. If you have purchased a pegboard back wall, posts and wall cabinet, refer to the owner's manual for the pegboard back wall and posts for how to install them on your base cabinet. WARNING: DO NOT STACK A BASE 4-DRAWER CABINET ON TOP OF ANOTHER CABINET.
INSTALLATION If you have purchased other units, assemble them now, then put all units together to build your garage. For a better appearance, attach units together using a M6 x 16 hex socket head screw and M6 hex flange nut. Holes are located at the top front side of each unit.
Hide holes on the exterior ends of the units with the supplied end covers, if necessary.
For safety, secure the tops of the each unit to the wall using three M6 x 65 hex tapping screws and washers. For best results, mount to studs or other solid surfaces. Do not mount to drywall as it will not support the required weight and poses a danger if mounted incorrectly.
OPERATION RAISE AND RELEASE DRAWER FRONTS These units are equipped with raise and release drawer fronts. To open, lift up on the drawer front while pulling towards you. To close, shut the drawer firmly until the latch engages. Lift If the drawer does not stay closed, the hook may be bent, or it may be rubbing against the drawer slides. To fix this problem, lightly bend the hook until the drawer will engage in the slide. DRAWER REMOVAL Pull the drawer out so that it’s almost fully extended.
MAINTENANCE Periodically clean the door and drawer fronts, trim, and other surfaces with mild detergent and water. Lubricate the slides (twice a year) with a product like WD40 or other quality lubricant. This is especially important in low temperatures, which can cause the bearing to become stiff. Grease and oil can be removed with most standard cleaning fluids. For safety, use a nonflammable cleaning fluid. SAFETY Use two people to move the units into place.
This product is warranted to be free from defects in materials and workmanship for a period of five (5) years from the date of original purchase. If this product is defective, email service@montezumastorage.com or call 1-800-459-4409 (Monday–Friday, 8:00 am–4:30 pm, CST). If the product is defective, we will replace the defective part at no cost to you. Please do not ship your product back to the store or to us unless we send you written instructions for return.
Manufactured by: QUALITY CRAFT Romeoville, IL, USA 60446 service@montezumastorage.com 1-800-459-4409 (Monday to Friday, 8:00 am–4:30 pm, CST) Made in China www.montezumastorage.
