Instructions / Assembly

7
Position the support bar so the slot passes
through the tab on the bottom shelf with
the power tool slots. Secure the bar by
lining up the hole at the top of the support
bar with the corresponding hole on the top
shelf. The support bar should be positioned
behind the front edge of the top shelf.
Secure using a bolt and nut.
INSTALLATION
This unit can be installed onto a Montezuma
garage storage pegboard or on a wall.
To install on a Montezuma pegboard, line up
the holes of the organizer with the pegboard
holes, and secure using nuts and bolts.
You will need access to the back of the
pegboard panel – installation may be easier
with two people.
If you are installing the organizer on a wall,
you will need to secure one side into a wall
stud and use the plastic anchors in the
drywall/sheet rock.
Hold organizer in place with a level and
make sure it is straight, then mark holes in
the drywall for the plastic anchors. Pre-drill
pilot holes.
Secure the self-tapping screws and plastic
drywall anchors into the marked locations,
leaving enough room to position the
organizer in place using the keyhole slots.
Then tighten down the screws to secure the
organizer in place.
Note: For safety and security, the organizer
should be mounted into at least one stud wall.
7"
8.75"