Instructions / Assembly

7
Take two of the four cross bar pieces and slip them together with the top flanges facing in
the same direction. You will see three sets of four holes – you can join the two cross bars
together at any of these hole patterns. (The other end of each cross bar only has two
holes, which will attach to a leg assembly.)
For a 4' wide work top, line up the four holes labeled A in the illustration below with the
four holes labeled D. For a 5' work top, line up the four holes labeled B with the four holes
labeled D. For a 6' work top, line up the four holes labeled C with the four holes labeled D.
Secure the cross bars together with four (4) nuts and bolts, but do not tighten all the
away.
Repeat with the remaining set of cross bars. Make sure that the cross bars are secured
at the same hole patterns so they are the same length.
Line up the holes in the two assembled cross bars with the holes in the top of the leg
assemblies. The cross bar flange will overlap the legs at each end. Secure each cross
bar to the top of each leg using two (2) nuts and bolts.
Connect the braces from the cross bars to the leg assembly to improve stability, using
two (2) nuts and bolts for each brace.
Do not tighten fasteners until all legs are connected to the cross bars and braces. Once
all legs are connected, use a level to make sure the frame is straight, then tighten all nuts
and bolts.
A
B
C
D