OWNER'S MANUAL 3-TIER STEEL MOBILE REVOLVING TOOL CART MRTC2623B www.montezumastorage.
LIFE ORGANIZED Montezuma is committed to helping you succeed in both your work and personal life by being organized, prepared and equipped with the right tools, gear and home supplies at your finger tips. Keep your life organized with Montezuma. Thank you for your purchase of this Montezuma Revolving Tool Cart. ATTENTION TO REDUCE THE RISK OF INJURY, THE USER MUST READ AND UNDERSTAND THIS INSTRUCTION MANUAL BEFORE USING THIS PRODUCT FOR THE FIRST TIME. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
SPECIFICATIONS MAXIMUM PRODUCT WEIGHT (INCLUDING CONTENTS): 660 lb (300 kg) OVERALL DIMENSIONS: 27-5/8" W x 36-1/8" D x 48-1/4" H (70.1 cm W x 91.8 cm D x 122.4 cm H) MAXIMUM DRAWER WEIGHT: 100 lb (45.
PARTS LIST REF DESCRIPTION PART NUMBER QTY 1 Tray Liner 552215 1 2 M8 x 70 mm Wing Bolt 321218 6 3 Wing Nut 323151 10 4 Rigid Caster 302032 2 5 Washer 324008 24 6 M8 x 20 mm Hex Bolt 321024 24 7 Swivel Caster 302031 2 8 End Cap 314073 1 9 Drawer Liner 552216 1 10 Slide Set 300022–300023 1 11 Middle Tier Foam Insert 552212 12 12 Top Tier Foam Insert 552211 1 To order replacement parts, email service@montezumastorage.
1 6 10 M8 x 70 mm Wing Bolt Wing Nut Tray Liner 4 for attaching the support arms For protecting the top tray 2 for attaching the top tray For use with some M8 x 70 mm Wing Bolts and M8 x 20 mm Hex Bolts 2 24 24 Rigid Caster Washer 16 for installing casters For attaching to the bottom of the cart For use with M8 x 20 mm Hex Bolt 8 for attaching the revolving tool organizer 2 1 1 Swivel Caster End Cap For attaching to the bottom of the cart For attaching at the end of the support arm
CASTER INSTALLATION Carefully lay the bottom tray upside down, with a soft mat underneath for protection. Be careful not to damage the post support when you turn over the bottom tray. Position the two swivel casters on the bottom of the tray, opposite of the post support on the left and right side. Insert four M8 x 20 mm hex bolts through washers, then through each caster fastening hole and into the bottom of the tray. Tighten securely.
Attach the revolving plate to the support arm using four M8 x 20 mm hex bolts, washers and wing nuts. NOTE: Use only the top set of holes in the revolving plate. TIP: Rotate the revolving plate a quarter of a turn so that the top set of holes are easier to access when attaching the support arm. Carefully turn the revolving 3-tier tray upside down. Make sure it is on a flat, stable surface. Attach the revolving 3-tier tray to the other side of the revolving plate using four M8 x 20 mm hex bolts and washers.
Insert the staging tray. Attach using two M8 x 70 mm wing bolts and wing nuts. Tighten securely.
RAISE AND RELEASE DRAWER FRONTS This unit is equipped with a raise and release drawer front. To open, lift up on the drawer front while pulling towards you. To close, shut the drawer firmly until the latch engages. If the drawer does not stay closed, the hook may be bent, or it may be rubbing against the drawer slides. To fix this problem, lightly bend the hook until the drawer will engage in the slide. Lift DRAWER REMOVAL Pull the drawer out so that it’s almost fully extended.
MAINTENANCE Periodically clean the drawer front, trim, and other surfaces with mild detergent and water. Lubricate the casters with high quality bearing grease (annually/yearly). Lubricate the slides (twice a year) with a product like WD40 or other quality lubricant. This is especially important in low temperatures, which can cause the bearing to become stiff. Grease and oil can be removed with most standard cleaning fluids. For safety, use a nonflammable cleaning fluid.
5 This product is warranted to be free from defects in materials and workmanship for a period of one (5) years from the date of original purchase.* If this product is defective, email service@montezumastorage.com or call 1-800-459-4409 (Monday–Friday, 8:00 am–4:30 pm, CST). If the product is defective, we will replace the defective part at no cost to you. Please do not ship your product back to the store or to us unless we send you written instructions for return.
Manufactured by: QUALITY CRAFT Romeoville, IL 60446 service@montezumastorage.com 1-800-459-4409 (Monday to Friday, 8:00 am–4:30 pm, CST) Made in China www.montezumastorage.
