Rear Tine Tiller Operating Manual

2. Hook the "Z" end of tine clutch cable into the
hole in tine clutch lever.
3. With the clutch lever released (in the "up"
position), adjust the bottom nut at the cable
bracket so there is only a slight amount of
slack in the control wire. Tighten the upper
nut against the bracket. Squeeze the clutch
lever against the handle. The control wire
~should now be straight. See figure 10.
NOTE
Do not overtighten control wire.
Too much tension may cause it to
break.
FIGURE 10.
ATTACHING THE DRIVE CONTROL CABLES
1. The drive clutch cables are already attached
to the unit. Attach the other end of cables to
the upper hole of drive clutch lever (W), one on
each side, using hex bolt (R) and hex lock nut
~(S). See figure 11.
2. Remove one nut and the lock washer from the
end of each drive clutch cable. Thread the
other hex nut all the way down the cable as far
as it will go as shown in figure 11.
FIGURE 11.
~J
FIGURE 12.
7