MONTICELLO GREENHOUSE OPTIONAL IRRIGATION SYSTEM INSTALLATION MANUAL Riverstone Industries Corporation www.RSIWW.com Customerservice@RSIWW.
12' 1 1 1 1 2 4 2 1 White Hose Line End Plug 12'' Mister w/ Tip Threaded Line End Brass Hose Adapter B‐3 Bracket Zip Ties Set Screw Assemblies Programmable Timer 8' x 8' 1 3 5 2 1 1 2 1 16' 8' x 12' 1 4 6 2 1 1 3 1 20' 8' x 16' 1 5 7 2 1 1 4 1 24' 8' x 20' IRRIGATION ‐ Part List 1 6 8 2 1 1 5 1 28' 8' x 24'
SOME PARTS SHOWN IN SILVER ARE USED ONLY TO CONTRAST FROM THE BLACK FINISH OF THE GREENHOUSE IN THIS MANUAL. The views on this page are from inside the greenhouse and facing the door. The Irrigation System can be installed on the left or right side of the door (inside view). This manual shows installing on the left side of the door. 1 set screw assembly B‐3 bracket 1a 2 2a STEP 1: On the left side of the door frame, at the bottom photo 1, remove the exsisting B‐3 bracket shown in silver photo 1a.
Set Screw Assembly The views on this page are inside the greenhouse and facing the door. STEP: 4 Insert a new set screw assembly into the track of the door frame photo 4. Slide set screw upward and place B‐3 bracket onto set screw assembly photo 5. Tighten set screw assembly 4 5 STEP: 5 Slide a set screw assembly photo 6 (shown in yellowish color photo 6a) downward into the track approximately 2'' at the top of the door frame.
8 irrigation hose The views on this page are from the inside of greenhouse and facing the back wall. STEP: 7 Locate the irrigation hose. Lay the hose on top of the roof truss braces B‐9 as shown in photo 8. The end of the hose that is "capped off" needs to point in the direction opposite the door. Attach the hose at the peak of the greenhouse using the supplied zip ties. Photo 9 shows the first attachment point; over the last roof truss brace.
12a 12 The views on this page are from the inside of greenhouse and facing the door. 13 STEP: 8 After attaching the hose to the roof truss bracket nearest to the door, guide the hose toward the left side of the door frame and attach to the B‐3 bracket that was installed in Steps 5 & 6 photo12 & 12a. Next, attach the hose using zip ties to the B‐3 bracket from Step 2 photo 13. STEP: 9 Connect a water hose to the end of the irrigation hose. Locate the Irrigation Controller(provided).
Page 5 www.RSIWW.