Use and Care Manual

WWW.RSIWW.COM
24 of 45
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
NOTE: VIEW FROM INSIDE.
NOTE: Panels will not fit completely to end of channels.
There will be some space to allow for temperature changes.
IMPORTANT: The panels expand and contract depending on the temperature.
To ensure proper placement, use the 23 1/8 inch spacer included with the tools.
Working from inside front right corner, place 23 1/8 inch spacer on base next to
F-7 corner profile. Position left F-8 profile so single set screw is next to
base on inside and the cut edge angled down toward the nearest corner
when installed. B-2 connector is pointing towards door opening. Fit
panel into channel in F-8 profile and slide F-8 profile against spacer
to ensure proper placement.
5.3A
5.3B
Continue working from inside right
corner, place F-6 profile with mitered
end next to corner and angled edge
facing up onto corner W-1 panel. F-6
profile fits snugly between F-7 and
F-8 profiles.
5.3c
Secure B-2 with two T-bolt assemblies
and one S-2C cap as shown.
5.3D
W-1
F-7
spacer tool
F-8
B-2
W-1
F-7
F-8
G-1
F-6
Connector
QTY
B-2 1
S-2C 3
W-1 1
Panel
QTY
24” x 57”
Use B-3 connector with T-bolt
assemblies as shown to secure
to base.
B-3
F-8
B-2