Use and Care Manual

ATTACHING 1" X 1" ANGLE AROUND FAN AND SHUTTER OPENINGS

Measure the bottom of the opening and notch the 1" x 1" angle leaving

1" extending beyond the opening on both ends. (See photo 1)

Slide the angle into the opening and attach it from the outside using the

# 12 x 1" tek-screws provided as shown in photos 2 & 3.

Repeat these steps for the top of the opening.

1" Notch

On the side of the opening measure and notch the angle on both ends

as shown in photo 4.

Using this 45 degree notch will dress up the looks of the opening but is

not required. If you would rather use the same notch used on the top

and the bottom pieces this is perfectly acceptable

1" Notch

and

the

bottom

pieces

this

perfectly

acceptable

Slide the angle into the opening allowing it to lap over the extended

portion of the top and bottom pieces and attach it from the outside

using the # 12 x 1" tek-screws provided as shown in photos 5 & 6.

If the H-splice extrusion on your endwall, falls out beside the fan

opening as shown in photo 7, you will not use 1" x 1" on this side.

IMPORTANT:

The 1" x 1" aluminum angle is intended to be used

around the fan and shutter openings only.

For more Information on

trimming other openings, see next page.

H-S

lice

1" x 1"

Angle

Page 26