Use and Care Manual

PREVENTATIVE MEASURES
Eave extrusion
Splice
End of plastic
locking cap
Caulk around
the corners
Final Note:
If the greenhouse is not put into operation immediately and you do not have the fans, shutters,and cooling system
operating, we highly recommend that you prop open all shutters, doors and vents. This will help prevent the greenhouse
from overheating and causing the thermostats to loose their calibration. (Thermostats will loose calibration if
temperatures exceed 120 deegrees F).
FAILURE TO PROPERLY VENTILATE THE GREENHOUSE, WILL RESULT IN THERMOSTST DAMAGE. THIS IS
NOT COVERED BY THE MANUFACTURER'S WARRENTY!!!
After you have completed the greenhouse, use clear caulking to seal any places water might leak
We recommend drilling "weep" holes in the outside
edge of the eave extrusion, this allows trapped
condensation to drain out. Drill 1/8" holes approx.
36" apart on the eaves only.
Page 34