Use and Care Manual

CENTER CONNECTOR
BOLT HOLE
for RIDGE
EXTRUSION
#14 x1''
TEK
SCREWS
HALF BOW (95'')
1
4
" NUTS
5
16
" x 2
1
2
"
CARRIAGE BOLT
1
4
" x 2
1
4
"
U- BOLT
PURLIN HANGER
"L" BRACKET (aluminum)
5
16
" NUT
2'' X 2''
HALF BOW
RAFTER ASSEMBLY
1. Identify rafter/bow parts (refer to packing slip for specific quantities of each part)
2. Attach "L" brackets to half bows as shown below for a 16' wide Scholar.
3. Slide half bows onto center connector and secure with #14 x 1'' tek screws.
4. Attach U-bolts to each "L" bracket using
1
4
" nuts - do not tighten at this stage.
Purlin Hanger "L" brackets MUST be
facing the inside of the greenhouse
on END BOWS.
Brackets on Intermediate rafter can
be placed on either side of the rafter.
HALF BOW (95'')
pre-punched
truss upright
hole
pre-punched
truss upright
hole
Page 4