Specifications

ManualsBrandsMontigo ManualsHome building and Decor36DV-SH

11/93

Page 1 of 13

INSTALLING AND OPERATING

YOUR MONTIGO 36DV-TV

GAS-BURNING FIREPLACE

Please leave this manual with the owner

CHECK LOCAL CODES PRIOR TO INSTALLATION

FOR YOUR SAFETY FOR YOUR SAFETY:

IF YOU SMELL GAS:

1. OPEN WINDOWS. DO NOT STORE OR USE ANY FLAMMABLE

2. DON'T TOUCH ELECTRICAL SWITCHES. VAPOURS OR LIQUIDS NEAR THIS OR ANY

3. EXTINGUISH ANY OPEN FLAME. OTHER GAS-BURNING APPLIANCE.

4. IMMEDIATELY CALL YOUR GAS SUPPLIER.

READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING

MODEL

MONTIGO 36DV-TV

CANADIAN HEATING PRODUCTS INC.

12091 88th Avenue, Surrey, B.C. Canada; Phone: (604) 597-3115 Fax: (604) 597-3096

Summary of content (10 pages)

PAGE 1
INSTALLING AND OPERATING YOUR MONTIGO 36DV-TV GAS-BURNING FIREPLACE Please leave this manual with the owner CHECK LOCAL CODES PRIOR TO INSTALLATION FOR YOUR SAFETY IF YOU SMELL GAS: FOR YOUR SAFETY: 1. OPEN WINDOWS. 2. DON'T TOUCH ELECTRICAL SWITCHES. 3. EXTINGUISH ANY OPEN FLAME. 4. IMMEDIATELY CALL YOUR GAS SUPPLIER. DO NOT STORE OR USE ANY FLAMMABLE VAPOURS OR LIQUIDS NEAR THIS OR ANY OTHER GAS-BURNING APPLIANCE.
PAGE 2
INTRODUCTION INSTALLING THE FIREPLACE The Montigo 36DV-TV is rated at 18,000 BTUs. (4.7 Kilowatts) for Natural & Propane gas. The Montigo warranty will be voided by, and Montigo disclaims any responsibility for, the following actions: - Modification of the fireplace and/or components including Direct-Vent assembly or glass doors. - Use of any component part not manufactured or approved by Montigo in combination with a Montigo fireplace system. - Installation other than as instructed in this manual.
PAGE 3
DIRECT VENT TERMINATION LOCATION This section is used to determine where your direct vent termination will be located. VENT TERMINATIONS SHALL NOT BE RECESSED IN WALLS OR SIDING. INSTALLATION OF DIRECT VENT A complete Montigo 36DV-TV vent system may comprise of six individual components: (see figure 5. page 4) A - Termination B - Stucco Kits CAUTION C - Solid section & elbow 1).
PAGE 4
C A A 7 1/2 ft. from center of fireplace 10 ft. from center of elbow Solid section includes 90 degree elbow D Stucco Can Vent Termination B E 3 ft. flex section 4" B F 10" 43" Hearth FIGURE 7. RETRACTED 10' SECTION FIGURE 5. TYPICAL INSTALLATIONS. 3, or 4 ft. flex section turned 90 degrees. Stucco Can Vent Termination 3 ft. Max HORIZONTAL VENTING All vent pipes must maintain a minimum of 1" clearance to combustible materials.
PAGE 5
INSTALLATION OF VERTICAL DIRECT VENT A complete Montigo 36DV-TV vertical vent installation may comprise of the following components: A - Termination B - Flex sections C - Solid sections D - Support Ring & Plate E - 7" Firestop F - Roof Flashing Storm collar Roof flashing 2 Feet MVTK-1 MFL-1 (1' 6" section) MFL-2 (2' 6" section) MFL-3 (3' 6" section) MFL-4 (4' 6" section) MEXT-1 (1' section) MEXT-2 (2' section) MEXT-3 (3' section) MEXT-4 (4' section) MEXT-6 (6' Section) MSPXT-7 (7" Support Plate & Ring)
PAGE 6
VENTING GRAPH Venting graph is used for top vent direct vent model only. How to use the venting graph: 1 Determine the height for the centre of the 7" vent elbow and mark a horizontal line until it intersects with the slanted graph line. 2. From the point of this intersection draw a vertical line to the bottom line of the graph.
PAGE 7
FIREPLACE MANTEL AND FACING Combustible mantels and mouldings may be safely installed over the top and on the front of the fireplace provided that they do not project beyond shaded area shown in figure 10A. Side wall clearances are 0". Combustible surrounds may be installed with 0" clearance to the side of the fireplace as shown in figure 10B.
PAGE 8
REMOVAL OF OUTER DOOR INSTALLING LOG SET Easily removed for cleaning and servicing. Although this pane is made of a very tough tempered glass, always handle it carefully and place in a safe location where it will not be broken or damaged. To remove the outer glass panel lift upwards and outwards. This will release the panel from the mounting pins. See Figure 11. The Montigo 36DV-TV is supplied with four(4) very attractive cultured oak logs.
PAGE 9
TROUBLESHOOTING PILOT BURNER ADJUSTMENT 1. Remove Pilot Adjustment Cap. (see figure 14) 2. Adjust pilot key to provide properly sized flame. See Figure 15 for properly sized flame. 3. Replace pilot adjustment cap. 4. Leak test with a soap solution after installing or servicing with main burner on. Coat pipe and tubing joints, gasket etc. with soap solution. Bubbles indicate leaks. Tighten any areas where the bubbles appear until the bubbling stops completely.
PAGE 10
MONTIGO 36DV-TV DECORATIVE GAS FIREPLACES WARRANTY THE WARRANTY Canadian Heating Products Inc. warrants the Montigo 36DV Decorative Gas Appliance to be free from defects in materials and workmanship at the time of manufacture. On the Montigo 36DV there is a ten-year warranty on the firebox and its components, a five-year warranty on the main burner, pilot burner and cultured oak logs, and a one-year warranty on the gas control valve and glass doors.