Owner`s manual

Page 16
B-Series DV-2 Gas Fireplace
Part No. XG0160 - 080410
Installation
Installing the Log Set
Installing the Logs:
The B-Series DV2 is supplied with ve ceramic bre logs. Unpack the
logs and handle them very carefully.
1. Remove the door cover and the glass door.
2. Place the Back log onto the back log rest as shown below in gure
29. The log has lip on the bottom which ts into the slot on the log rest.
3. Place the Front log onto the front log rest as shown in gure 29.
Center the log from side to side, and push it against the back of the
log rest. Carefully push the log onto the metal spikes on the log rest.
4. Place the top logs in position as shown in gure 29a, place the
centre log down rst, then the right and left logs.
5. Start the replace. If the ame appears satisfactory, replace the
glass door and door cover.
Cautions:
Q If logs are not placed properly, excessive sooting will result.
Q The surface of the logs will crack due to the heat of the
ames. This is a normal occurrence.
Figure 29. Positioning for the front and back logs.
Figure 29a. Proper log placement.