Installation guide

Page 12Page 12

Page 12

C38-DV Gas Fireplace

Part No. XG0118B

Removing and Installing

the Door

Removing the Door:

Remove the trim (as described on the next page) to access the door

latches. Open the latches by pulling Part A upwards and towards you

to disengage Part B from the door. Lift Part B clear of the door.

Repeat for all three latches. Be sure to hold the door carefully so it

does not fall. (See figure 23a.)

Installation

Once the three latches are unhinged, tilt the top of the door forward

and lift it out of the slots. See figures 23b and 23c.

Figure 23a. Operating the door latches.

Figure 22a. Wiring for optional air circulating fan kit.

L1-WH

L2-BLK

Quick Connect

plug to motor

Wiring for the optional Fan Kit

All C38-DV fireplaces may be equipped with optional fan kits (Part

no. RFK1001, RFK1003, RFK1006 or RFK1007)for circulating heat

into the living space.

Installations in Canada which employ the fans must be electri-

cally grounded in accordance with CSA C22.1 Canadian Electrical

Code Part 1 and/or Local Codes.

Installations in the USA which employ the fans must be

grounded in accordance with local codes or, in the absence of

local codes, with the National Electrical Code, ANSI/NFPA 70-

1987.

For more information see the Fan Kit Installation Guide included

with the fan kit.

NOTE: If any of the original wire supplied with the appliance is replaced, it

must be replaced with the same type, or its equivalent.

Figure 22b. Wiring schematic for optional fan kit.

115/1/60 Supply

G L1 L2

Figure 23b. Removing the door.