Installation guide

Page 15Page 15
Page 15Page 15
Page 15
C38-DV Gas Fireplace
Part No. XG0118B
with Pilotless (Spark-to-Burner) Ignition
Operation - Model C38-DV-S
C38-DV-S
A. This appliance does not have a pilot. It is equipped with an
ignition device which automatically lights the burner. Do not
attempt to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What To Do If You Smell Gas:
n Do not try to light the appliance.
n Do not touch any electrical switch. Do not use any phone in
your building.
n Immediately call your gas supplier from a neighbour's
1. STOP! Read the safety information above on this label.
2. Make sure the wall switch is in the "OFF" position. Flip down the lower
horizontal trim.
3. Wait 5 minutes to clear out any gas. If you smell gas, STOP! Follow "B" in
the safety information above on this label. If you don't smell gas, go to step
4.
4. Find the indicator light on the control module, located under the fireplace near
the gas control valve. If the indicator light is flashing slowly, the system is
ready for lighting.
5. Turn on the wall switch. You will hear a 'ticking' sound as the system
attempts to light the fireplace. If successful, the main burner will ignite, and the
indicator light will flash quickly.
If not successful, the system will automatically close the gas valve to stop
the flow of gas. The indicator light will double flash, and the system will lock
out for five minutes.
6. Flip up the lower horizontal trim.
1. Turn off the wall switch.
phone. Follow the gas suppliers instructions.
n If you cannot reach your gas supplier, call the Fire Depart-
ment.
C. Do not tamper with, or attempt to repair the gas control valve. If
the system does not operate properly, call your service techni-
cian or gas supplier. Force or attempted repair may result in a
fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and any
gas control which has been under water.
2. If service is to be performed, turn off all electric power to the appliance.
Control Module
Indicator Light
Rear Burner Tube
Ignitor / Flame
Sensor Probe
OUT
Gas Control Valve
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
For Your Safety - READ BEFORE LIGHTING:
To Turn Off Gas To Appliance:
Lighting Instructions: