Installation Operation & Maintenance Double Burner Pedestal Gas Stove Model DFSP Warning: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information consult a qualified installer, service For Your Safety: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any Check local codes and read all instructions prior to installation.
DFSP Rio Pedestal Stove Table Of Contents Quality Gas Products by Montigo Introduction About the Rio Pedestal Stove: Introduction.............................................................................. 2 Installation Choosing a Location....................................................... 3 Installing the Gasline....................................................... 4 Direct Vent Installation.................................................... 4 General Requirements.............................
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Installation Choosing a Location The fireplace may be installed in any location that maintains clearances to air conditioning ducts, electrical wiring and plumbing. Safety, as well as efficiency of operation, must be considered when selecting the fireplace location. Try to select a location that does not interfere with room traffic, has adequate ventilation, and offers an accessible pathway for vent installation.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Installation Installing The Gas Line The gas line must be installed before completing the installation. Natural Gas requires a minimum inlet gas supply pressure of 5.5" W.C. & a manifold pressure of 3.5" W.C. Propane Gas requires a minimum inlet gas supply pressure of 11" W.C. & a manifold pressure of 10" W.C. Provision must also be made for a 1/8" N.P.T.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Installation Direct Vent Installing Terminations with Built-In Frames 10 MTO-3 10 1. Frame the termination opening to 10" x 10". 2. Fasten the termination to the studs using a minimum of 4 Installing Rio 'Snorkel' Terminations See Rear Vent Venting Runs section for Snorkel Installations. Installing Heat Guards over Terminations 25" Figure 6. RearVent installation, showing the required components and the height of the stove's flue collar.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Installation Direct Vent Slide the inner wall plate back against the wall. Level the plate, making sure it completely covers the opening in the wall, and fasten it in place using four wood screws. (Note that the heat shield connected to the plate is not concentric -- its top edge should sit close to the inside top edge of the 11" x 11" hole.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Installation Direct Vent Top Vent Venting Runs For the Rio Pedestal Stove there are two types of Top Vent (DV) installations: A) Horizontal (Through-The-Wall) Installations and B) Vertical (Through-The-Roof) Installations. Allowable Vent Runs Before you install any venting, you must determine whether the venting run will be acceptable. Unacceptable venting can affect the fireplace's combustion.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Installation Direct Vent B) Vertical (Through-The-Roof ) Venting Option 4. Install the first stove pipe onto the conversion box by sliding it over the flex pipe (refer to Figure 14). Install a spacer spring around the flex liner. Secure the pipe with at least two ½" hex screws spaced approx. 3/4" from the joint. Slide the remaining vertical stove pipes into place, without fastening them. Install a spacer spring inside each stove pipe section. 5.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Installation Direct DirectVent Vent Installing the Stove Pipe 1. Ensure that the intended pathway for the venting is clear.Try to position the stove midway between two joists to avoid having to cut them. Cut and frame a 11" x 11" hole in the ceiling and roof as required. 8. Move the stove into position below the stove pipe. Slide the bottom section of stove pipe down over the collar on the top vent conversion box.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Installation B-Vent B-Vent Installation This Rio Stove is certified for use with standard B-Vent, when installed using Montigo's optional B-Vent Conversion Kit (part # FSTK03), and provided the following steps are carefully followed. Stove Pipe, Liner, and B-Vent are not included with the kit. Refer to Step 5. Spill switch When vented with standard 4" B-Vent, the B-Vent is installed directly onto the draft hood assembly.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Installation Removing and Installing the Door Removing the decorative door cover: The door cover is held in place by two clips at the top, and two pins on the botton. Locate the latch shown in figure 24 and pull down. While holding the latch down, pull the cover out at the bottom and then downward until the clips at the top are clear. (See figure 24.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Installation Wiring for the optional Blower Kit Center logs Back log Left log The Rio Steel Stove may be equipped with an optional variable speed blower kit (Part #RFK1080) for circulating additional heat into the living space. Right log Installations in Canada which employ the blower kit must be electrically grounded in accordance with CSA C22.1 Canadian Electrical Code Part 1 and/or Local Codes.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Operation - Continuous Pilot Models For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell all around the appliance area for gas.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Operation - Intermittent Pilot (-I) Models For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance is equipped with an ignition system that lights the pilot burner automatically. Do not attempt to light the pilot by hand. B. BEFORE LIGHTING smell all around the appliance area for gas.
Quality Gas Products by Montigo Operation Lighting Instructions See pages 13 and 14. Adjusting the Burner Raising or lowering the Flame Height Rio Stoves are equipped with an adjustable burner, allowing you to raise or lower the flames. To adjust the flames, locate the black knob marked 'Flame Control', in the centre of thecontrol panel (See Figure 31). To raise the flame height, turn the black knob marked 'Flame Control' counterclockwise. To lower the flame height, turn clockwise.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Maintenance Troubleshooting Gas Control Valve HONEYWELL SV9500 /9600 Troublshooting Sequence Power Generator On/Off Switch NOTE: Before Troubleshooting, Familiarize Yourself With START TH The Startup And Checkout Procedure. SV9500 / SV9600 is powered (24VAC nominal) NO TH-TP TP YES Figure 32. Honeywell VS8520 gas valve. Pilot Burner Adjustment 1. Locate Pilot Adjustment Screw. (See figure 32.) 2.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Warranty The Warranty The Companies warrants the DelRay Gas Appliance to be free from defects in materials and workmanship at the time of manufacture. On the DelRay, there is a ten-year warranty on the firebox and its components, a five-year warranty on the main burner, and a one-year warranty on the gas control valve, pilot burner and fibre logs. Glass, plated/painted finishes, and refractory lining are exempt.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Appendix A - Accessories and Vent Components Accessories Item Description Quantity Order Code 1 2 3 4 1 1 1 1 RX-10 Wireless Remote Control Millivolt Thermostat Millivolt Thermostat Variable Speed Blower Kit Programmable Non-programmable Includes heat sensor, variable speed control. Vent Kits Item Description Vent Components - Avail.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Appendix A - Accessories and Vent Components Direct Vent - Through-the-Roof Kit Direct Vent - Rear Vent Kit 6 36 14 5 10 7 8 9 32 34 11 13 33 41 32 37 Direct Vent - Through-the-Wall Kit 35 38 18 21 16 39 40 16 31 19 29 17 26 Part Description 22 28 25 Spare Parts List 16 23 24 15 Part No.
DFSP Rio Pedestal Stove Quality Gas Products by Montigo Appendix B - Termination Locations A = clearance to the termination frame above grade, veranda, porch, deck, or balcony [16 inches (41 cm) minimum] B = clearance to door, or sides and top of window, that may be opened [16 inches (41 cm) minimum for appliances ≤100 000 BTU/H (30kW)] C = clearance to bottom of window that may be opened horizontally [36 inches (92 cm) minimum for appliances ≤100 000 BTU/H (30kW)] D = no clearance to permanently closed
Quality Gas Products by Montigo DFSP Rio Pedestal Stove Appendix C - State of Massachusetts Amendment (Gas Fireplace / Equipment sold in the State of Massachusetts) 5.08: Modifications to NFPA-54, Chapter 10 (1) Revise NFPA-54 section 10.5.4.
Quality Gas Products by Montigo XG0509 - 120507 Canadian Heating Products Inc. Montigo Del Ray Corp.
