Installation guide

Page 11
Part No. XG0509
DFSP Rio Pedestal Stove
Quality Gas Products by Montigo
Installation
Removing and Installing
the Door
Removing the decorative door cover:
The door cover is held in place by two clips at the top, and two pins
on the botton. Locate the latch shown in figure 24 and pull down.
While holding the latch down, pull the cover out at the bottom and
then downward until the clips at the top are clear. (See figure 24.)
Removing the door:
Remove the 8 nuts around the edge of the glass door, and then pull
the door outwards and upwards until it is clear of the door rail.(See
Figure 25). Ensure that a good seal is maintained when re-installing
the door.
Figure 24. Removing or installing the door cover.
Figure 25. Removing or installing the glass door.
Latch
Pin
Clips
Nuts
Glass door
2. Unpack the logs. Be sure to handle the logs carefully, as they are
very fragile.
3. Place the Back log onto the back log rest as shown below in
figure 26. The log has lip on the bottom which fits into the slot on
the log rest.
4. Place the Front log onto the front log rest as shown in figure 26.
Center the log from side to side, and push it against the back of
the log rest. Carefully push the log onto the metal spikes on the
log rest.
5. Place the top logs in position as shown in figures 27 and 28.
6. Start the fireplace. If the flame appears satisfactory, replace the
glass door and door cover.
Figure 26. Positioning for the top logs ('C' and 'D' ).
Installing the Log Set
Installing the Logs:
The double burner Rio Stove is supplied with six (6) fibre logs. Un-
pack the logs and handle them very carefully.
1. Remove the door cover and the glass door.
Back log
Left log
Right log
Front log
Center logs
Figure 27. Proper placement (top view).
Back log
Front log rest
Back log rest
Heat exchanger tubes
Front log
Front burner tube
Back burner tube
Ember tray