Operating instructions

ManualsBrandsMontigo ManualsKitchen AppliancesDFSP

 Check local codes and

read all instructions

prior to installation.

 Leave this manual with

the owner.

For Mobile /Manufac-

tured Home approved

models:

 DXFS

 DFSP

 DXFS-MH

 DFSP-MH

Gas Conver-

sion Instruc-

tions

This appliance may be installed as an OEM installation in a manufactured

(mobile) home and must be installed in accordance with the manufacturer's

instructions and the manufactured home construction and safety standard,

Title 24 CFR, Part 3280 or Standard for Installation in Mobile Homes, CAN /

CSA Z240 MH.

This appliance is only for use with the type(s) of gas indicated on the rating

plate. A conversion kit is supplied with the appliance.

Warning: If the information in these instructions is not followed

exactly, a ﬁre or explosion may result causing property damage,

personal injury or loss of life.

 Do not store or use gasoline or other ammable vapors and liquids in the

vicinity of this or any other appliance.

 What To Do If You Smell Gas:

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor's phone. Follow the gas

supplier's instructions.

• If you cannot rea

ch your gas supplier, call the re department.

 Installation and service must be performed by a qualiﬁed installer, service agency or

the gas supplier.

Summary of content (6 pages)

PAGE 1
Gas Conversion Instructions For Mobile /Manufactured Home approved models:     DXFS DFSP DXFS-MH DFSP-MH This appliance may be installed as an OEM installation in a manufactured (mobile) home and must be installed in accordance with the manufacturer's instructions and the manufactured home construction and safety standard, Title 24 CFR, Part 3280 or Standard for Installation in Mobile Homes, CAN / CSA Z240 MH. This appliance is only for use with the type(s) of gas indicated on the rating plate.
PAGE 2
Gas Conversion Kit for DXFS/DFSP-MH models Table Of Contents General Information.................................................................. 2 Parts list..................................................................................... 2 Conversion Before you begin............................................................. 3 Front Burner.................................................................... 3 Rear Burner....................................................................
PAGE 3
Gas Conversion Kit for DXFS/DFSP-MH models Gas Conversion Instructions Conversion CAUTION - Before you begin: 1. Shut off gas at the shut-off valve. 2. Remove the glass door as shown in the installation instructions and remove the logs. The pilot orifice has a small marking on the side to indicate its size and which gas it is for. Ensure that you have the correct orifice in the pilot hood. (See figure 3.) Power Pile Igniter Pilot Hood Thermocouple Front Burner: 3.
PAGE 4
Gas Conversion Kit for DXFS/DFSP-MH models Gas Conversion Instructions Checking the Gas Pressure Main Gas Control Regulator Screw: 11. The stove models use the Honeywell Hi/Lo gas control valve, which has a removable regulator screw. The kit will include a new regulator screw, the red screw is for Propane (LP) and the blue screw is for Natural Gas (NG). It is located in the middle of the hi/lo knob, replace it, and install the new regulator screw.
PAGE 5
Gas Conversion Kit for DXFS/DFSP-MH models Operating Instructions For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell all around the appliance area for gas.
PAGE 6
XG0667 Rev. 00 - 07/02 Canadian Heating Products Inc. Montigo Del Ray Corp.