Owner`s manual

Page 7
H42DF-O Outdoor Gas Fireplace
Part No. XG0149
Installation
Converting to Top Vent/ Rear Vent
H-Series DF Top Vent
Use the following instructions to convert an H42DF-O for Top Vent
use:
Install the 4" or 5" inner ue cap on the rear ue outlet and secure 1.
the cap in place with ve screws, as shown in gure 7a.
Install the 7" or 8" outer ue cap on the rear ue outlet, and secure 2.
it with ve screws, as shown in gure 7a.
Install the ue gasket material and ue cover plate on the rear vent 3.
outlet . Fasten the plate with four screws, as illustrated below.
Install the 4" or 5" inner ue collar and the 7" or 8" outer ue 4.
collar in place on the top vent outlet using 5 screws, as illustrated
below.
Figure 7a. Flue cap installation for Top Vented replace.
Figure 7b. Flue collar installation for Top Vented replace.
Figure 8a. Flue cap installation for Rear Vented replace.
Figure 8b. Flue collar installation for Rear Vented replace.
H-Series DF Rear Vent
Use the following instructions to convert an H42DF-O for Top Vent
use:
Install the 4" or 5" inner ue cap on the top ue outlet and secure 1.
the cap in place with ve screws, as shown in gure 8a.
Install the 7" or 8" outer ue cap on the top ue outlet, and secure 2.
it with ve screws, as shown in gure 8a.
Install the ue gasket material and ue cover plate on the top 3.
vent outlet. Fasten the plate with four screws, as illustrated in
gure 8b.
Install the 4" or 5" inner ue collar and the 7" or 8" outer ue 4.
collar in place on the rear vent outlet using 5 screws, as illustrated
below.
Important: Natural Gas and Propane equipped models
may be installed using Top or Rear Vent applications.
However, the Propane equipped H42DF-O models must
be installed in a top vent application only.
5” Inner Flue Cap
8” Outer Flue Cap
5” Inner Flue Cap
8” Outer Flue Cap
5” Inner Flue Collar
8” Outer Flue Collar
5” Inner Flue Collar
8” Outer Flue Collar