Owner`s manual

Page 22
H-Series DL Gas Fireplace
Part No. XG0140 - 092210
Top Right Log
Embers
Embers
Embers
Top Left Log
Fireplace Base
Notch
Fireplace Base
Front Left
Base Log
Front Right
Base Log
Notch
Notch
Fireplace Base
Rear / Bottom Log
Notch in Log
Log stand
Log stand
Pilot Assembly
Fireplace Base
Air Inlets
Log 'D'
Installing the Logs:
The H34DL* is supplied with ve ceramic bre logs. Unpack the logs
and handle them very carefully.
1. Remove the glass door as described on Page 21.
4. Place the top left log as shown in gure 29d. A at area is
provided on the front left log, and a notch in the Rear bottom log,
as shown in gure 29c.
Figure 29a. H34DL*'s Fireplace Base.
Figure 29b. Bottom/Rear log placement.
Figure 29d. Top Left log placement.
Figure 29e. Top right log placement.
6. Start the replace. If the ame appears satisfactory, replace the
glass door. If the ame does not appear satisfactory, double-
check the air inlet and exhaust outlet pipe to ensure that they are
unobstructed.
Figure 29c. Front base logs placement.
2. Install Bottom Rear log as shown in Figure 29b.
3. Install Both front base logs, (Figure 29c) on the log stands provided.
See Figure 29b.
5. Place the top right log as shown in gure 29e. A notch is pro-
vided on the front right log, and a impression in the Rear bottom
log.
Installation
Section 8: Installing the Accessories
Installation
CAUTION!
If logs are not placed properly, excessive sooting will result.
The surface of the logs will crack due to the heat from the
ames. This is a normal occurance.