Owner`s manual

ManualsBrandsMontigo ManualsLawn and GardenH-Series DF

Page 7

H-Series DL Gas Fireplace

Part No. XG0140 - 092210

Installation

Section 3: Venting

Figure 9. Flue cover and collar removal, Top Vented replace.

Figure 9a. Flue cover and collar installation, Rear Vented replace.

Section 3-1: CONVERTING TO REAR VENT

Use the following instructions to convert an H*DL* for Rear Vent use:

1. Remove the Rear ue cover and gasket (4/5" and 7/8") on the

ue outlet, as shown in Figure 9.

2. Next, Remove the Top ue collar's (4/5" and 7/8") on the ue

outlet, as shown in Figure 9.

3. Install the (removed) Rear ue cover and gasket material, to the

Top vent outlet. Fasten the cover with included hardware, as

illustrated Figure 9a.

4. Install the (4/5" and 7/8") collars to the rear vent outlet using the

included hardware, as illustrated Figure 9a.

Montigo supplies a variety of direct venting and termination options.

The direct vent termination location MUST be selected such that

it is the highest point in the venting assembly. It should also be

selected such that it provides the shortest vent run possible. Should

it be impossible to ensure that the termination is the highest point

or to meet the venting guidelines laid out below please contact your

Montigo dealer to discuss power venting options.

NOTES FOR PLANNING VENTING:

 Venting can originate from the unit through the top or

through the rear

 Venting can terminate through the roof or through an

exterior wall.

 Refer to Appendix A - Termination Locations to ensure the

planned termination location is acceptable.

 Once the termination location has been established, refer

to the appropriate section below for installation details

 All replaces shipped from the factory are Top vent.

See Section 3-1 for converting the unit from top vent to rear vent.

Flue Gasket

Flue Cover Plate

4” Inner Flue Collar, H34DL

5” Inner Flue Collar, H38DL & H42DL

7” Outer Flue Collar, H34DL

8” Outer Flue Collar, H38DL & H42DL