Operating instructions

ManualsBrandsMontigo ManualsHome building and DecorH34D

 Check local codes and

read all instructions

prior to conversion.

 Leave this manual with

the owner.

For models:

H34D

Gas Conver-

sion Instruc-

tions

Warning: If the information in these instructions is not followed

exactly, a ﬁre or explosion may result causing property damage,

personal injury or loss of life.

Do not store or use gasoline or other ammable vapors and liquids in the

vicinity of this or any other appliance.

 What To Do If You Smell Gas:

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor's phone. Follow the gas

supplier's instructions.

• If you cannot rea

ch your gas supplier, call the re department.

Installation and service must be performed by a qualiﬁed installer, service agency or

the gas supplier.

Summary of content (6 pages)

PAGE 1
Gas Conversion Instructions For models: H34D Warning: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. Do not store or use gasoline or other flammable vapors and liquids in the    • • • • vicinity of this or any other appliance. What To Do If You Smell Gas: Do not try to light any appliance. Do not touch any electrical switch; do not use any phone in your building.
PAGE 2
Gas Conversion Kit Table Of Contents General Information.................................................................. 2 Parts list..................................................................................... 2 Conversion Before you begin............................................................. 3 Install or Remove the Air Inlet Screw.............................. 3 Converting the Burner Orifice......................................... 3 Converting the Pilot Assembly.........................
PAGE 3
Gas Conversion Kit Gas Conversion Instructions Conversion CAUTION - Before you begin: 7. 1. Shut off gas at the shut-off valve and disconnect the electrical supply (if used). 2. Remove the glass door as shown in the installation instructions and remove the logs. Flip down or remove the lower trims. Burner Orifice Install or Remove the Air Inlet Screw: 3. 4. Unscrew the coupling assembly from the pan base. The burner orifice is located at the top end of coupling.
PAGE 4
Gas Conversion Kit Gas Conversion Instructions 9. Install the new orifice from the conversion kit to convert to the pilot to the new gas. Tighten the orifice securely with an allen key. Re-attach the pilot hood, making sure the notch in the hood lines up with the tab on the pilot assembly. Checking the Gas Pressure To check the Inlet and Manifold gas pressures, a Water Column Pressure Gauge with 5/16" dia. tubing can be used. To test the Manifold Pressure, loosen the screw shown in Figure 7.
PAGE 5
Gas Conversion Kit Operating Instructions For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
PAGE 6
XG0675 Rev. 00 - 12/2003 Canadian Heating Products Inc. Montigo Del Ray Corp.