Owner`s manual


Page15
XG0649 - 031511

Figure 7. Framing the Opening for Power Vent
14 1/2”
14
1/2”
(Opening)
(Opening)
Step2.
Insert the Power Vent Rough-in Box as shown in Figure 7a

Fasten the Box securely in place with Screws or nails

Apply exterior
sheathing and nishing if required

Step3.
Next, remove the bottom collar and conduit mounting frame as
shown Figure 7b

(Place removed hardware in a handy location for
re-assembly)

F
igure 7a.
O
rientation, Placing the Power Vent Inner Box
Framing
Rough-in Frame
Fasteners
Figure 7b. Installation of Rough-in Kit
Installing the external wall mounted power vent module
Step1. Construct a frame for the termination opening to meet the
following requirements:
■ Opening Size must be: 14 1/2" x 14 1/2"

Figure 7c. Installation of Power Vent Conduit
Power Vent Conduit
Strain Relief
Nut
Step4.
Insert the conduit from the Power Vent Module into the rough-in
frame through the two top right entry holes

Remove the nut from the
supplied strain relief and place as shown, Figure 7c

Strain Relief
Figure 7d. (Installing Conduit connector & conduit mounting frame)
Power Vent Conduit
Strain Relief & tightened nut
Power Vent
Connector
Conduit
mounting
frame
Step5.
S
ecurely fasten bottom Collar pan into the Rough-in frame using
the existing hardware, (4-pcs)

Tighten Strain Relief nut onto Strain
relief

Step6.
P
ull Power Vent Connector, (from behind) half-way through
supplied hole in conduit mounting frame, and snap into place, (notches
in two plastic wing clips

Orientation not critical)

Tightened hardware, 4-pcs.
Step7.
Fasten Conduit mounting frame into place using existing hardware,
(6-pcs) (Coil conduit in behind cover)