Owner`s manual


Page25
XG0649 - 031511

Section7:Installing&RemovingtheDoor
Installing & Removing the Door
Removing the doors:
The doors are removed in a few simple steps

Follow the steps below to remove the Vertical Door trim, place the
Door removal tool, and then remove the door Replace all the parts
in reverse order
Step1. Remove the two (2) Vertical Trim pieces, (LH & RH) Pulling
rmly with your ngers, remove from the bottom then the top (See
Figures 17 & 17a) Other side Typical
Figure 17. (Remove LH Trim) Figure 17a. (Remove RH Trim)
Step2. Remove the supplied glass lifting tool from the packaging
Place in the center of the Glass door as shown, and activate the
suction feature of the tool, Figure 17b NOTE: Read ALL the instruction
supplied with the tool, and follow the associated operating procedures
F
igure 17b. Supplied Glass lifting tools.
To install the door, follow Steps 1 and 4 above, (in reverse order)
 H
ook
the top edge of the door frame into place

Lower and rest the door
frame in place and fasten the buckles

See gures 28a and 28b

Installing the Door:
Figure 17c (Lift the door
upward)
Figure 17d

(Lift the bottom of
the door outward)

Figure 17e.
Step
3.
 Hold the Glass Removal Tools rmly, Lift the door upward,
into the top door frame, Figure 17c

Then pull the bottom of the glass
door downward, and tilt outward from the bottom replace door frame

Figure 17d

NOTE: Read ALL the instruction supplied with the tool,
and follow the associated operating procedures

S
tep
 4
.

Still holding the Glass
Removal Tool rmly, remove the door
outward, and away from the Fireplace,
Figure 17e

Step 5. Place the door in a safe
location while maintenance, cleaning
or other operation are in progress
NOTE:ReadALLtheinstruction
s
upplied
 w
ith
 t
he
 t
ool,
 a
nd
followthe associatedoperating
procedures.
Step
6. To replace, See Installing
the
Door,Below.
Lift Upward into
the door frame.
Lift Downward
& away from frame.
Do not use ammonia based or abrasive
cleaners on the glass, they will
permanently etch the surface. Use an
approved gas fireplace glass cleaner
such as Kel-Kem or White off.
NOTICE
XW2000