Owner`s manual


Page26
XG0649 - 031511

Section8:InstallingtheLogSet
Installing the Logs:
The H36PVNis supplied with six (6) piece ceramic bre logs Install
as described below:
Step
1
. Unpack the logs and handle them very carefully

Set them
aside in a safe location until required

Figure 18d. Location of Log 'A'.
Figure 18. Packaged LogSet as supplied from Montigo.
Step2. Locate the Log Back Pan Retaining clip, Figure, 18a above
and remove, Figures, 18b & 18c Place in a safe location
(Philips head screwdriver required).
Step
3
. Position Back Log 'A' from the previously unpacked package,
(Figure 18)

Place the Log upright, (as shown Figure 18d) and
move the Log ush against the sheet metal Back Pan

Without
pressing the Log down, move it as far to the left as possible,
bumping the bottom Left corner against the alignment tab,
(Figure 18a & 18d)

Lastly, Press the Log FIRMLY downward,
onto the sharp spikes, shown in Figure 18a & 18e.
Step4. Once the 'Back Log 'A' is in it's nal Position, hold the log
in place, and reinstall the Retaining Clip (removed earlier)
Press down the Clip for the sharp teeth to penetrate into the
top of the Log (Figure 18g) (Philips head screwdriver
required).
Figure 18e. Alignment of Log 'A'.
Figure 18a. Log Grate Details & identication.
Figure 18b. Figure 18c.
Log A
Figure 18g. Securing Log 'A'.
Log D
Spikes
Log D Rest
Log C Rest
Log C
Spikes
Log E Spike
Log A Retaining Clip
Log A
Alignment Tab
Log B cradle
& Spike
Log B Rest
Left end Rest
Log A back-pan
Log A Spikes
Log ‘A’ Spikes
Figure 18f. Log 'A' Spikes, Figure 18a.
Alignment Tab
Move Log ‘A’ left
and bump against
Alignment Tab