Owner`s manual
Page28
XG0649 - 031511
Section9:Start-upSequence
1) Turn the wall switch ON
2)
T
he blowers will start and within 10 seconds the glow plugs will
start to glow
3) If the pilot does not light the gas valves willl turn the glow plugs
off after 20 seconds
4) This may need to be done three or four times to bleed all of the
air out of the gas lines within the replace
5) Turning the switch OFF and then ON again will reset this start
up sequence
6)
O
nce the pilots are burning the main burner will turn on and
the replace will be functional for a quick start up on next use
If the information in these instructions is
not followed exactly, a fire or explosion
may result causing property damage,
personal injury or death.
WARNING
XW2008
■ This fireplace has been set up at the factory for a
determined air volume though the venting system.
■ This fireplace will not operate unless the correct
air movement is detected by our control system..
■ Please consulted with your contact person at
Montigo should you have any problems with your
start up.
CAUTION
XW2040