Owner`s manual
Page29
XG0649 - 031511
To Turn Off Gas To Appliance:
1 Turn off remote switch
2
R
emove the lower Horizontal access panel
3 Turn the incoming gas control valve to "Off"
4
R
eplace the lower Horizontal access panel
with American Flame Electronic Ignition
For Your Safety - READ BEFORE LIGHTING:
Proame SIT Electronic Ignition
Lighting Instructions:
Immediately call your gas supplier from a neighbour's phone. Follow the gas
supplier's instructions.
I
f you cannot reach your gas supplier, call the Fire Department.
C. Use only your hand to push in or turn the gas control knob. Never use tools.
If the knob will not push in or turn by hand, don't try to repair it, call a qualied
service technician. Force or attempt to repair may result in a re or explosion.
D.
D
o not use this appliance if any part has been under water. Immediately
call a qualied service technician to inspect the appliance and to replace any
part of the control system, and any gas control which has been under water.
A
T
his appliance is equipped with an ignition system that lights
the pilot burner automatically
Do not attempt to light the pilot
by hand
B BEFORE LIGHTING smell all around the appliance area for
gas Be sure to smell next to the oor because some gas is
heavier than air and will settle on the oor
W
hat To Do If You Smell Gas:
Do not try to light any appliance.
D
o not touch any electrical switch; do not use any phone in your building.
1 STOP! Read the safety information above on this label
2 Remove the lower Horizontal access panel
3
T
urn Incoming gas valve to the ON" position
4 Wait 5 minutes to clear out any gas If you smell gas, STOP!
Follow "B" in the safety information above on this label If you
don't smell gas, go to the next step
5
T
urn wall switch "ON"
6 If the Fireplace does not light, the System will cycle through two
trials, (one minute audible clicking, thirty seconds of silence, and
then another one minute of audible clicking) If the system locks
out due to inadequate gas ow, refer to "Troubleshooting", Page
20
7
A
fter completion of the information in the Troubleshooting section,
Repeat step 5
8
I
f the system will not function correctly, follow the instructions
"To Turn Off Gas To Appliance" and call your service technician
or gas supplier
EV1 (Pilot
burner)
EV2 (Main
burner)
Pilot Adjust Screw
Lockout Reset Key
Diagnostic Terminal
Power
Command (Wall
switch)
Pilot Sensor
Igniter
Ground
EV1 (Pilot burner)
EV2 (Main burner)
Gas "Out"
Gas "In"
Incoming Gas
Line, Shut-off
Valve
To fireplace
Main burner
If the information in these instructions is
not followed exactly, a fire or explosion
may result causing property damage,
personal injury or death.
WARNING
XW2008