Owner`s manual


Page30
XG0649 - 031511

1
2
Removing the Log Grate:
The H36PVNis supplied with a log Grate that is fastened directly to
the base of the Fireplace To remove the Grate, to perform certain
Maintenance functions, follow the steps described below:
Step
1
.
C
LOSE
G
AS
V
ALVE
A
T
I
NCOMING
T
O
F
IREPLACE, (By
Qualied Persons ONLY, See 'Before You Start' in the Index).
Step2. Remove the two (2) machine screws that hold the Pilot
Assembly in place, Figure 20 (Philips head screwdriver required).
Figure 20. (Pilot mounting machine screws).
3
Step3&4Remove the two (2) (RH & LH) Base mounting machine
screws, Figure 20a & 20b (Philips head screwdriver required).
Figure 20a. (LH Base mounting
machine screw).
4
Step5. Loosen, and Remove the Flexible Gas hose (at tting),
(turn clockwise, left to right) Figure 20c & 20d (3/4" Open end
wrench required).
5
5
Figure 20b. (RH Base mounting
machine screw).
5
1
2
3
4
Figure 20c. (Gas tting).
NOTE: Ensure all 5-steps are complete before removing Log Grate.
(Failing to do so may damage the exible gas hose, or mounting
hardware of the grate). Figure 14e.
Figure 20d. (Loosening Gas tting
on burner).
Removing the Refractory:
The H36PVNis supplied three (3) pieces of rebox refractory Lining
These panels are fastened directly to the interior sides, and back
of the Fireplace rebox with brackets To remove the brackets and
panels follow the steps described below:
Step
1
. Remove the RH-TOP machine screw that hold the Side
Refractory panel in place, then the bottom, Figure 22
 (P
hilips head
screwdriver required).
Step2. Remove the RH-Refractory panel from the rebox, Figure
22 (Place the Refractory panel somewhere safe where it will not
get chipped or damaged).
Step
3
. Follow step1 & 2 to remove the LH-Side Refractory panel,
Figure 22
 (P
hilips head screwdriver required).
Figure 20e. (Log Grate Removal Sequence).
Figure 22. (Removing Refractory panels).
Step
1&2
.
F
igure
2
0.
(
Pilot mounting
machine screws).
Step 3 & 4. Figure 20a. (LH Base
mounting machine screw). Figure
20b. (RH Base mounting machine
screw).
Step
5
.
F
igure
2
0c
&2
0d

Loosen, and
Remove the Flexible Gas hose (at
tting), (turn clockwise, left to right)
(3/4" Open end wrench required).
LH-Panel
RH-Panel
Back-Panel
Bottom
Brackets
Top
Brackets