Owner`s manual

Page 20
H*38DF-PFC* Indoor Gas Fireplace
Part No. XG0816 - 100210
Installation
Section 8: Installing the Accessories
WARNING!
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etching
may cause premature glass failure.
Do not operate this replace without the glass door, or with a
broken glass door.
Figure 27b. (Place Logs' "A" on Left & Right stands).
Installing the Logset
The H38PF* is supplied with eight (8) bre logs. The two small bottom
logs ("A" ) are mounted on the burner grate by placing them diago-
nally onto the supplied Log stands. The long Front / Back logs ("B")
are placed against the grate as shown in Figure 27c. Note: When
placing logs, arrange Logs "B" as not to cover Burner holes.
Next are the Top logs "C" which are placed diagonally, as shown in
Figure 27d. The last Logs "D" are then mounted on top of logs "A"
as shown in Figure 27e.
Figure 27d. Log Installation. (Place Logs' "C" on-top of Logs "A".
Indentations on-top of Logs' "A"
Figure 27c. (Place Logs' "B" as shown, in front of Right-hand "A",
and behind Left-hand "B".
Log A
Log B
Log C
Log A
Log C
Figure 27e. Completed Installation.
Figure 27a. (Empty rebox showing the Left & Right stands).
Front of Fireplace
Burners
Log Stand
Log Stand
Burner holes (front & back burner),
note hole pattern when placing logs
Air Inlets
WARNING!
If logs are not placed properly, excessive sooting will result.
Installing the Ember Material
The ember material is supplied in two packages. Spread the mate-
rial evenly around the burner tray, or pile around burner holes for a
realistic effect.