Owner`s manual

Page 12
H52-DF Gas Fireplace
Part No. XG0650
Mantels & Surrounds
NOTE: National Canadian Gas Association mantel test requirements
are for re hazard prevention to combustible materials.
New technology, to meet consumer and government demands for the
wise use of energy, has prompted us to manufacture many models of
replaces which are hot, fuel and energy efcient.
Please be aware; temperatures over the mantel will rise above normal
room temperature and walls above replace may be hot to touch.
Figure 14. Combustible surrounds.
Non-Combustible
Facing Material
Header
Drywall/
Sheetrock
6”
Installing the Log Set
Installing the Logs:
The H52-DFN is supplied with seven ceramic bre logs. Unpack the logs
and handle them very carefully, install as described below.
Figure 16. Installation of four (4) Base Logs.
Step 1. Place the Base Logs, "A", "B", "C" & "D" as shown. Move them
left, or right to ensure they t between the grate stiles as shown.
Figure 16a. Installation of Log E.
Step 2. Place at portion (underside) of Log "E" on the formed steel Log
Rest as shown, lay front end of Log "E" approximately centre of
Log "B". See Figure 16 above.
Figure 16b. Installation of Log F.
Step 3. Place Log "F" in place as shown. Rest front end of Log "F" in
curved area (notch) see Figure 16a on Log "D", and rear of Log
"F" on log Grate, between back stiles.
Installation
Log Grate
Log C
Log A
Log D
Log Rest E
Log B
Log E
Log Grate
Notch
Log D
Log B
Log Grate
Log F
plateau
plateau