Instruction manual

Section 3: Finishing
Figure 1 Sec.3 Combustible mantles and facings. (Not to scale)
Fireplace Facing
When selecting the nish material for your replace, it is important
to remember the following:
If the surround of the replace is to be painted to match the room decor,
heat-resistant paint must be provided . Also, decorative facing must
not extend past the replace opening at all, because it will interfere
with the access to retainers for removal of glass door and access to
the lower compartment.
Mantels & Surrounds
NOTE: National Canadian Gas Association mantel test requirements
are for re hazard prevention to combustible materials.
Please be aware; temperatures over the mantel will rise above normal
room temperature and walls above replace may be hot to touch.
Warning:
We recommend careful consideration be given to the effects of
elevated mantel temperatures which may be in excess of product
design, for example: candles, plastic or pictures. This can cause
melting, deformation, discoloration or premature failure of T.V. and
radio components.
12 11 10 9 8 7 6 5 4 3 2 1
Combustible
construction allowed
in shaded area
Start of combustible
framing
Combustible
facing material
Top of
fireplace
Glass
Non-combustible
headers supplied by
Montigo (may be
placed where required
for fastening facing)
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
Note: Images are shown without screens for clarity purposes.
However, your replace should not be operated without proper
installation of screens.
R520-ST & R620-ST Power Vent Indoor Gas Fireplace
Page 11
XG0773 - 150127
Installation