Owner`s manual

Page 14
C-View Residential R520-R620 Series Indoor Gas Fireplace
Part No. XG0771 - 0070111
f i r e f e a t u r e
Installation
Figure 16. Fireplace installation, (Rough Frame-In dimensions).
Step 2. Place the Fireplace on the platform and install the Vent pipe, and Power Vent module. (Install the module in a location where it can be
accessed when the surround is installed around the replace). Next, Connect the Gas line, and provide a gas service shut-off valve; according
to local gas codes. Before fastening in place Line up the front face of the replace (top and botttom), Figure 6a. then secure in place with 1/4"
wood screws.
Step 1. To ensure your glass viewing area is at the optimum height, follow the Example below, Figure 16. Example: If you wish to have the
bottom edge of the glass to be 24", the top of the platform will be 13". This dimension takes in account the height of the platform, plywood and
adequate clearances.
Figure 16a. Fireplace installation, (Inlet Gas & Power Vent).
1/2”
Supply Gas
connection
Intake / Exhaust
Venting
Step 3. Back-framing the Fireplace; installing 2 x 4's.
Ensure you have the required 2 x 4's to complete the project. Cut One 2 x 4 to t under the replace throat, (horizontal), t & remove. Next, cut
the short 2 x 4's, under the previous Horizontal. (Note: when these pieces are secured into place there should be the required 1" clearance to
Q (Opening)
R
(Opening)
U
3/4”
Plywood
Drywall
or Equiv.
Platform
Framing Dimensions
R
R520
R620
77”
89”
45”
45”
**27”
**27”
Q
U
** See Figure 1a.