Specifications

  Install the Power Vent Roof top stainless steel cover over the
installed Rough-in Kit, see Figure 11d. The Electrical connector is located
in the corner, see Figure 11e.
 Installed stainless steel cover.
 Install the Power Vent module power harness. Hold the Power
Vent in close proximity to the assembled chase. With stainless steel cover
attached, plug in the power harness. Note the direction and orientation of
the plug socket, see Figure 11e.
Electrical Harness
from Power Vent
 Installed power harness.
Install Power Vent Module
with Power Harness
Vertical Roof Top
Power Vent
Vertical Roof Top
Power Vent Rough-in
Kit
 Installing Power Vent module.
 Secure the Power Vent module with three stainless steel fasteners
angled at 120°, penetrating through the inner stainless steel vent cover,
see Figure 11g.
Stainless Steel
Fasteners
 Completed Power Vent module installation.
Install screws around perimeter of Rough-in Kit. Drill holes supplied
for ease of installation, see Figure 11c.
Install Fasteners around
perimeter of Rough-in Kit
 Fasten Rough-in Kit to framing
Electrical Harness
Power Vent
Rough-in Kit
Electrical Harness
Connector Location

 Installing the Rough-in Kit.
 Install the Power Vent module. Place the Power Vent module over
the stainless steel cover ange and vent pipe. Align the Power Vent into nal
position. Ensure the power harness is placed down in the rough-in box. The
Power Vent module will sit ush with the stainless steel cover when installed
correctly, see Figure 11f.

Page 18
XG0771 - 040513
