Full Product Manual

Montserrat Rigid Core Vinyl (SPC) Flooring Installation and Maintenance
Please contact your local dealer for questions and further information
!
!
1!
RIGID CORE VINYL (SPC) FLOORING
Installation and Maintenance
IMPORTANT
READ INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION. This flooring is intended for indoor use only.
Residential installation does not require acclimation, as long as the floor is allowed to sit and brought up to room
temperature prior to installation. Commercial installation requires a 24 hour minimum acclimation period. Make sure the
subfloor is clean, dry and flat. Inspect ALL material carefully for color, finish, sheen and defects PRIOR to installation.
Material with visible defects found after installation are not covered under warranty.
Installation implies acceptance of the quality, dimensions, and appearance of the flooring. Should there be any doubts
regarding the aforementioned aspects, please contact your dealer/distributor and do not proceed with installation until you
are satisfied with your flooring.
OTHER THINGS TO NOTE
Samples are designed to be a representation of the actual product. Your finished flooring may contain a varying ratio of
knots, saw marks, splits, cracks, streaks, and/or color contrast. Samples under varying light sources including sunlight and
room lighting may result in a difference of appearance of the flooring under each condition.
While Rigid Core Vinyl (SPC) flooring is a 100% waterproof and fire resistant material, it is not meant to act as a
moisture barrier for the home. It is best practice to test for moisture and take action promptly and accordingly.
Store product boxes flat and ensure they are fully supported during shipping, handling, and storage. Rough handling can
cause damage to the flooring prior to installation.
Rigid Core Vinyl (SPC) flooring can be heavier than expected. Always use proper lifting techniques with handling.
Whenever possible, use material handling equipment and/or have assistance from shipping and handling professionals.
Avoid direct sunlight exposure to minimize the effects of fading of the flooring. Prolonged UV exposure will likely have a
uniform fading effect on building materials.
TOOLS REQUIRED
§ Power Saw
§ Tape Measure
§ Spacers
§ Rubber Mallet
§ Pencil
§ Straight Edge
Things to note: Do not use tape or adhesive products of any kind on the surface of the flooring. Doing so may discolor
and/or damage its finish.
Door jambs are recommended to be undercut.

Summary of content (4 pages)