User Manual

Part No:620010640
A.SPEED A.DEPTH A.CONTROL B.SPEED B.DEPTH B.CONTROL
Routing
MOD FACTORY PRO contains 2 independent Modulation modules (MODE
A/MODE B) which can operate individually or simultaneously. The internal signal
chain routing of the pedal can be adjusted using the ROUTING SWITCH.
1.Serial MODE A > MODE B
The signal will first go to MODE A and then to MODE B
When using this routing the TAP TEMPO controls the rate of MODE A
A B
2.Serial MODE B > MODE A
The signal will first go to MODE A and then to MODE B
When using this routing the TAP TEMPO controls the rate of MODE B
B A
3. PARRALLEL
The signal will first be split into 2 and then go to MODE A and MODE B
simultaneously
The signal will then exit both effect modules and be mixed together before
reaching the outputs of the pedal
When using Parrallel routing you can simulate a dry through WET/DRY setup by
disabling one of the effect modules. To achieve this simply set either MODE A or
MODE B to the ‘Off’ position.
Try setting MODE A to ‘Off’ and ‘MODE B’ to Vibrato whilst in PARRALLEL
routing to discover a very cool chorus type effect.
MODE A Off MODE B Off
Using Presets
MOD FACTORY PRO can store 4 presets which can be scrolled through live using
the PRESET footswitch. When you save a preset the pedal will store all of your
parameter value, routing and expression pedal settings.
The PRESET STATUS LEDs display which preset is currently selected. When the
RED LED is highlighted (on the far left) MOD FACTORY PRO is in pedal mode.
This means that all parameter values will be equal to their respective controls
physical position.
To scroll through presets, press and release the PRESET footswitch
To store a preset
Make all settings you wish to save
Press the STORE button once and the preset LED will begin to flash
Select the preset space where you wish to store your settings by pressing the
PRESET footswitch
Press the STORE button one more time to confirm or move any control on the
pedal to cancel the storage procedure
Connections
INPUT
EXP
DC 9V 300 mA
Expression Pedal
Expand the live performance experience of your MOD FACTORY PRO by using it
with an expression pedal. The expression pedal can be set to control any one
single parameter of the MOD FACTORY PRO.
Connect your expression pedal to the EXP input of the MOD FACTORY PRO
using a 1/4” trs stereo Jack cable.
Simultaneously rotate the control knob of the parameter you wish to set to
the EXP and rock the pedestal of your expression pedal back and forth
Now you have successfully set the expression pedal to control a parameter
of the MOD FACTORY PRO
Specifications
Input: 1/4 "mono jack (impedance 1M Ohms)
Output: 1/4 "mono jack x2 (impedance 100 Ohms)
Sampling rate: 44.1K
Sampling accuracy: 24bit
Power supply: 9V 300mA DC power supply (centre pin negative)
Power consumption: 250mA
Size: 106mm (D) X96mm (W) X53mm (H)
Weight: 400g
* Disclaimer: Specification update is subject to change without notice.
MOOER AUDIO CO.,LTD
www.mooeraudio.com