User Manual

Identify the folllowing part in the Large Plastic Bag of Parts:
(2) 50K linear taper potentiometers (labeled 50KB or B50K) w/ hardware: lockwasher, washer, and nut.
(2) 5K linear taper potentiometers (labeled 5KB or B5K) w/ hardware: lockwasher, washer, and nut.
(1) 50K audio taper potentiometer (labeled 50KA or A50K) w/ hardware: lockwasher, washer, and nut.
(1) Microphone Stand Flange
(5) Black Knobs w/ set screws
(2) 1/4" TRS Jack assemblies w/ hardware: lockwasher, washer, and nut.
(1) – Black plastic rocker switch
(1) – Nickel-plated Elbow Pipe Connector - 3/8" Pipe to 3/8" Tube
(2) – Nickel-plated Straight Pipe Connectors - 3/8" Pipe to 3/8" Tube
(3) – Brass Compression Rings (shipped attached to pipe connectors)
(3) – Nickel-plated Compression Nuts (shipped attached to pipe connectors)
(2) – Self-adhesive Felt Strips
(1) 5-wire harness
(1) Ten-wire female connector
(1) calibration tool
Step 2: Begin the assembly process with the step titled "Drilling the holes for the 11-213 PCB" on p.3 of the EPFUM.
Step 3: Once you have the three Holes drilled, proceed to p.10 of the ETUM and perform the step "Finishing the
Cabinet".
Step 4: When your cabinet is finished and dried, proceed to the step titled "Installing the Fittings" on p. 11 of the
ETUM.
Step 5: Once the antenna fittings and hardware are installed into the cabinet, select the 8" length of solid copper
bus wire. Cut it into two 4" lengths. Feed an end of one of the 4" wires through the solder lug on the pitch antenna
connector. Do not loop the end of the wire. Solder the wire to the solder lug. Feed an end of the other 4" wire through
the solder lug on the rear volume antenna connector. Do not loop the end of the wire. Solder the wire to the solder
lug.
Step 6: Proceed to the step titled "Installing the Upgrade" on p.4 of the EPFUM. The following differences exist:
"Step3) Reinstall the 11-211 Etherwave Circuit board and solder the antenna wires to the PCB antenna
connectors." Note: The word "Reinstall" should be read as "Install"; Details of installing the PCB into the cabinet
are found on p. 14 of the ETUM.
"Step 12) Reinstall the mic stand adapter." Note: Ignore this step, it is already done.
Step 7: Assembly is complete, refer to the EPFUM p.7 "Tuning and Testing" section.
The Etherwave Theremin User's Manual has a comprehensive overview of the theory and operation of the Etherwave
Theremin. We recommend reading this as it will enhance your understanding of this remarkable and unusual musical
instrument. We hope your Etherwave Plus provides you with many years of enjoyment and fun.
© 2009 Moog Music Inc. All Rights Reserved.
Moog Music Inc.
160 Broadway St.
Asheville, NC 28801
Phone: [phone] Toll-Free: 800-948-1990
Web: http://www.moogmusic.com
Email: [e-mail]