User Manual
116
LEFT HAND CONTROLLER FUNCTIONS (Continued)
X/Y PAD
Sliding a nger across the X/Y PAD controls two
individual parameters at the same time, in different
amounts. One is assigned to the X axis, the second
to the Y axis. There is also a third axis that can
sense pressure on the pad. Also, anytime the pad is
touched, a gate signal is created that can be used as
a Modulation Matrix source/controller or as a CV Out
source. The current X and Y values can be frozen using
the X/Y HOLD button. This held value can be saved as
part of the Preset, similar to the MOD wheel amount.
HEADPHONES
Moog One provides two 1/4” stereo headphones jacks, located on
the front edge of the LHC panel, allowing you and a friend to both
listen to Moog One without any external ampliers.
LHC MORE PAGE
Pressing the triangular MORE button in the upper right corner of the Left Hand Controller will reveal
a second level of parameters that can be accessed and modied using the interactive portion of the
Center Console. These additional parameters are displayed in the bottom portion of the screen. The
left pane shows a representation of the X/Y PAD surface. The red dot indicates the current position of
the nger on the pad, or the last held position if X/Y HOLD is On. The size of the dot image will change
as more pressure is applied to the X/Y PAD. The right pane shows the current value of the Front Panel
hardware parameters for this module. Tweaking these panel controls will update their values here.
NOTE: Pressing the (now) illuminated MORE button will exit the MORE page and recall the HOME screen.