User Manual

Table Of Contents

You can access additional Subsequent 25 hidden parameters using a combination of buttons and the

keyboard. First, engage Shift mode by holding down the BANK 4 button and pressing the ACTIVATE

PANEL button. Next use the BANK and PATCH buttons to choose the parameter. Finally, press a key

on the keyboard to set the parameter’s value. All parameter options are shown on the following pages.

All parameters have at least two possible values (ON and OFF), and some parameters have up to 24

possible values. Lower keys specify lower values, and higher keys specify higher values. Because most

parameters have a limited range of values, they respond to only the leftmost keys. The low C key always

selects the lowest value. For parameters with two values, the low C always selects OFF and the low

C# always selects ON. For parameters that use less than the entire keyboard to select values, unused

keys play normally, allowing you to audition sounds while you make parameter changes. Once you have

set the value for a hidden parameter, you can remain in the Shift mode and use the BANK and PATCH

buttons to call up another hidden parameter, or simply press the key used to set the parameter value

a second time to exit the Shift mode. You can also press the ACTIVATE PANEL button to exit the

Shift mode at any time.

PITCH

KEYBOARD TRANSPOSE

To transpose the entire keyboard to any pitch you choose, engage Shift mode,

press the BANK 1 and PATCH 1 buttons, and then press any key. Pressing a key

above middle C transposes up by the interval you select. Likewise, pressing a key

below middle C transposes down by the interval you select. For example, if you

press A below middle C, you will transpose the keyboard down 3 semitones, and

if you press C above middle C, you will transpose the keyboard up a full octave.

The maximum range is up or down 12 semitones.

NOTE: Middle C refers to the C key at the center of the Subsequent 25’s keyboard, not to

the pitch usually referred to as middle C, which is actually one octave higher.

PITCH BEND RANGE UP

The Subsequent 25’s pitch bend defaults to two semitones up or down, but you

can change either direction to any interval you want. To specify the PITCH wheel’s

range when you push it up, engage Shift mode and press the BANK 1 and PATCH 2

buttons. Pressing any key selects the bend interval, with each key increasing the

interval by a semitone as you go from left to right. If you want to bend up an octave,

for example, press the middle C key. The maximum range is 24 semitones up.

PITCH BEND RANGE DOWN

To specify the PITCH wheel’s range when you push it down, engage Shift mode

and press the BANK 1 and PATCH 3 buttons. Pressing any key selects the bend

interval, with each key increasing the interval by a semitone as you go from left

to right. If you want to bend down a perfect 5th, for example, press the low G key.

The maximum range is 24 semitones down.

HIDDEN PARAMETERS

Middle C