User Manual

Table Of Contents

HIDDEN PARAMETERS (Continued)

RESTORE FACTORY PRESETS

Engage Shift mode and press BANK 3, BANK 4, and PATCH 3. Press C# twice to

reload the 16 Subsequent 25 factory Presets.

NOTE: Invoking this command will delete any user Presets.

NOTE CALIBRATION

Engage Shift mode and press BANK 3, BANK 4, and PATCH 4. Press C# twice to

run a full-range note calibration routine for the two Oscillators. This will ensure that

the Oscillators remain in tune in every octave throughout their entire pitch range.

SEND CURRENT PRESET

Engage Shift mode and press the BANK 3, BANK 4, PATCH 1, and PATCH 2

buttons. Press C# twice to send all the settings for the current Preset to your

computer as MIDI system exclusive data. If you record this data on your computer

and then send it back to your Subsequent 25, it will replace the Patch that’s

currently loaded into the panel buffer. Once it’s in the buffer, you must manually

save the data to a Preset location if you don’t want to lose it.

SEND ALL PRESETS

Engage Shift mode and press the BANK 3, BANK 4, PATCH 3, and PATCH 4

buttons. Press C# twice to send all 16 Presets to your computer as a single Preset

Bank ﬁle. If you record this MIDI system exclusive data on your computer and

then send it back to your Subsequent 25, it will replace all 16 Presets stored in the

Subsequent 25 memory.

For additional hidden parameters and updates visit www.moogmusic.com/subsequent-25.